![]() The panel or Z-Wave controller should provide some visual indication to let you know that the lock has been cleared from the network. A distance of about one foot is recommended. When you go to exclude the lock, you should first bring the lock in close proximity to the panel or Z-Wave controller. You should refer to the instruction manual for your system to find out exactly how to access its Z-Wave exclusion mode.Ģ. Or your panel may have a automation menu for doing this. This mode is sometimes accessed by pressing a button directly on the Z-Wave controller. If your alarm system has a Z-Wave controller, then it will have some mode for excluding Z-Wave devices. Some panels may already have a Z-Wave controller installed, while others will need to have one added separately.Ĭomplete the following steps to exclude a Kwikset Z-Wave Lock and then pair it with your system:ġ. Keep in mind that a Z-Wave controller is needed to use a Kwikset Lock with an alarm system. By clearing the network first, you can be sure that the lock will successfully pair with your Z-Wave network when you go to do so. Many Z-Wave devices are paired with networks for factory testing purposes. Keep in mind that some Kwikset locks might not have this button.Įxcluding a Z-Wave device is always an important step before attempting to include it. It is recommended that you check the lock's manual for the button's exact location. It should not be confused with the lock's "B" button or "Program" button. This is usually a smaller button the is found under the lock's cover. The typical Z-Wave lock from Kwikset will have button labeled "A" that is used for both including and excluding the device from Z-Wave networks. You will then be able to successfully pair the lock with a new network. Doing this will clear the lock from the network. Some locksets incorporate both types of screws.You can exclude your Kwikset Z-Wave Lock by activating the Z-Wave exclusion mode on your system and then pressing the button marked "A" found underneath the lock's cover. Have on hand both a flat-head and Phillip's screwdriver to remove the deadbolt. Cut around the perimeter on both sides of the deadbolt using a sharp utility knife to avoid peeling or damaging the door's finish during lock removal. How do you remove a Kwikset two sided deadbolt? Remove the deadbolt latch by sliding it out the side edge of the door.Remove the two screws that hold the latch in place with the Phillips screwdriver.Remove the two mounting screws from the interior cover using the Phillips screwdriver.Pry off the inside deadbolt cover using a small flat-blade screwdriver.Once the screws are removed, the mounting plate and remaining half of the deadbolt will be free. Hold the exterior side of the deadbolt and remove the two mounting screws from the mounting plate located on the interior side of the door. How do you remove a Kwikset deadbolt with security screws? Open the door and remove the screws of the latch mechanism.Pry the plate using a flat screwdriver.Position in a way that you are facing the deadbolt from the inside part of your house.How do you remove a Kwikset deadbolt without visible screws? How to Remove a Kwikset Deadbolt Lock without Screws Instruction ![]() The clip will release from the plug as you move the clip side to side. Remove the clip on the side of the plug with a flat-head screwdriver or plug-removal tool. Hold the cylinder side of the lock in your hand with the inside of the lock facing you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |